Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
Here is a link to the sensor manual if that helps
https://www.allweatherinc.com/wp-content/uploads/8339-F-001-1.pdf
Page 17 talks about data communication specifically.
Good Day,
I'm working on troubleshooting a weather ceilometer that uses mainly RS485, but has the ability to use RS232. I'm using the IO Ninja Hardware Tap. When wiring the ceilometer for RS485, we so no data coming across, just DTR On DTR Off signals and .. response back.
When we wire it for RS232 we see a lot of Line error detected framing error. Although we do see the data expected, but it appears to be broken by Line error detected: Framing errors. I have attached a pic.
I'm assuming there is something wrong with the DAC for this ceilometer, but I just want to confirm that I am using your software and hardware properly.
Here is a picture I took of the data. According to the ceilometer manual the data should look like TR1 AAAAAA HHHHH TTTT HHHHH TTTT HHHHH TTTT HHHHH TTTT VVVV RRRRR which is what the picture attached sort of shows, but with those Line error detected between the packets I did however see TR1 AAAAAA HHHHH TTTT HHHHH TTTT HHHHH TTTT HHHHH TTTT VVVV RRRRR data come through the data logger at some point in testing, but I can never re-create that config.
Any help is greatly appreciated.
Thanks