@henry

@andrew-hsu
Hi yes i have been holding the md button while sending the command until i get the error mesage
I did manage to set the ID`s for the probes but when i try for the baud etc it doses not?
iI did however spott somthing while looking at the registers, can this have somthing to do wit it.
The id register does not have the (1)(2) behind it?

Does anyone else get error messages when you try to set new baudrate and parity for modbus devices?
Im quite new so im not sure what i do wrong, i managed to set ID`s for the devices but thats about it.

Im using the Tibbo busprobes (#BP1) , does anybody have any experience with them or with setting baudrate and parity?

Hi

I am quite new and I'm trying to set up some sensors with a plc.

For it to work I need to change the parity and baud rate, so they correspond to the plc limitations and other Modbus devices that are connected. I have already managed to set different ID`s for the sensors but im not able to write the new Baud rate and parity.
Baud from 38400 to 9600:

Parity fom none to even:

Whenever I try I get error messages. How do you change them?