Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
Hi All, I'm using a serial TAP board to sniff serial port , and sometime I get a "Line error detected: FRAMING" in log What mean this error and where it come from ?
Thanks for help.
Thierry
FRAMING error happens when the stop bit(s) is not set where it should be (so the byte frame was not correctly received). Unless it only happens occasionally (and I mean, almost-never kind of occasionally), it's a sign to double-check serial settings (baud rate, data bits, parity bit, stop bits) and wiring (make sure to minimize possible electrical disturbances).